The Validation Engineer responsibilities include but not limited to:
Designing and executing DVPs for the propulsion system requirements testing
Critically evaluating the requirements, designing the DVP, and executing the testing
Identifying the correct testing environment for each test case (i.e. HIL or vehicle)
Performing issues pre-analysis and possible solutions
Identifying critical and corner cases maneuvers based on the requirements to draw out potential failures
Activities are performed on Electrified-Hybrid Propulsion System architectures on HIL and vehicle.
Requirements:
**BSG is the 48 volt Belt Starter Generator, or Motor Generator Unit. It's the little electric motor that replaces the alternator on your engine that gives it the start/stop feature, when your engine shuts off at a stop light and then turns back on when you go to take off
Requirements:
Bachelor's Degree in Electrical, Mechatronics or a closely related engineering degree from an ABET accredited university
Minimum 3 years of relevant engineering experience (research graduate work may count towards experience)
Experienced in validating and releasing of Electric Components for Automotive applications
Self-starter with strong leadership, communication skills, and demonstrated problem solving ability
Experience with Design Failure Mode & Effects Analysis (DFMEA)
Experience with Design Verification Plan & Report (DVP&R)
Knowledgeable in regards to GD&T
Understanding of manufacturing and quality processes of electrical components Knowledge Demonstrated ability to work in a team environment
Onsite at CTC - Anywhere from 3-5 days per week
No driving a Stellantis vehicle is required
0-5% travel required. local, domestic, and international (supplier is in Europe). Most travel is during the day to local labs
Preferred Requirements:
Master degree in Electrical Engineering, Mechatronics Engineering, or a closely related engineering degree from an ABET accredited University
Components releasing experience
Knowledge in electrified powertrain propulsion systems
Knowledge in Power Electronics
Design for Six Sigma (DFSS) green / black-belt
Knowledgeable in use of Team Center with experience in NX in a production release environment